Distraction

From CNM Wiki
Revision as of 13:29, 24 November 2019 by Gary (talk | contribs)
Jump to: navigation, search

Distraction

According to the FAA AMT Handbook,

A distraction while performing maintenance on an aircraft may disrupt the procedure. [Figure 14-19] When work resumes, it is possible that the technician skips over a detail that needs attention. It is estimated that 15 percent of maintenance related errors are caused by distractions.

14-15 THE DIRTY DOZEN Twelve human factors for aircraft maintenance proficiency Lack of Teamwork Fatigue Lack of Resources Pressure Lack of Assertiveness Stress Lack of Awareness Norms Complacency Lack of Knowledge Distraction Lack of Communication MITIGATING THE RISK Once returning to the job, go back through all of the steps to ensure where you left off. Never leave tools or parts lying around. Secure them before leaving the area. Use a detailed checklist. A distraction could be anything that takes your mind off the task that is being done. Any distraction while working can cause us to think we are further ahead in the process than we actually are. Figure 14-19. Distraction. Distractions can be mental or physical in nature. They can occur when the work is located on the aircraft or in the hangar. They can also occur in the psyche of the technician independent of the work environment. Something as simple as a cell phone call or a new aircraft being pushed into the hangar can disrupt the technician’s concentration on a job. Less visible is a difficult family or financial matter or other personal issues that may occupy the technicians thought process as work is performed. This can make performance of the required maintenance less effective. Regardless of their nature, numerous distractions may occur during the course of maintaining an aircraft. The technician must recognize when attention to the job at hand is being diverted and assure that work continues correctly. A good practice is to go back three steps in the work procedure when one is distracted and resume the job from that point. Use of a detailed step-by-step written procedure and signing off each step only after it is completed also helps. Incomplete work can be marked or tagged, especially when the technician is pulled from the work by a distraction, and it is unknown 14-16 THE DIRTY DOZEN Twelve human factors for aircraft maintenance proficiency Lack of Teamwork Fatigue Lack of Resources Pressure Lack of Assertiveness Stress Lack of Awareness Norms Complacency Lack of Knowledge Distraction Lack of Communication MITIGATING THE RISK Ensure that lines of communication are open between personnel. Always look out for co-workers with safety in mind. Discuss specific duties when jobs require more than one person to eliminate any questions. Personality difference in the workplace must be left at the door. Organizations should emphasize that a lack of teamwork can ultimately effect the safety of maintenance work. Figure 14-20. Lack of teamwork. when work will be resumed and by whom. Disconnect any connector and leave it plainly visible if an installation is not complete. There is a tendency to think a job is finished when a component is “hooked up.” Similarly, when a step in the maintenance procedure is complete, be sure to immediately lock wire or torque the fasteners if required. This can be used as an indication that all is well up to that point in the procedure.